2.

How to configure trunk port on cisco packet tracer

A port on a switch is either an access port or a trunk port. free standing cattle panels for sale near me0. quick pantry meals

Step 15: show vlan. . 10. Create the subinterface G0/0.

I want the 2960 interface to pass traffic on 2 vlan's, 10 and 20.

0.

Type.

.

Free Cisco Packet Tracer 8.

A port on a switch is either an access port or a trunk port.

. 1Q). Vendor agnostic technology (IEEE 802. This is done by using the following commands on both SW1 and SW2: On SW1: SW1 (config)#interface fastEthernet 0/3 SW1 (config-if)#switchport mode trunk.

R1 (config)# int g0/0. danscourses. on trunk ports.

Switch (config)#vlan 10.
A Microsoft logo is seen in Los Angeles, California U.S. 29/09/2023. REUTERS/Lucy Nicholson

omnisecu.

. .

Create the subinterface G0/0. R1 (config)# int g0/0.

The above picture shows that the trunk link is connected to port fa0/24 on both switches.

conf t. Switch (config)# interface GigabitEthernet 0/0/10.

Issue the switchport mode trunk command to force the switch port to trunk mode.

.

. Router (config)#interface fa0/1. To verify how the trunk port is configured you can issue few show. .

b. The above picture shows that the trunk link is connected to port fa0/24 on both switches. . Jan 15, 2022 · Step 1: Use DTP to initiate trunking on F0/1.

On the Cisco ASR 1002 router you would have to create a sub interface and.

. . In this tutorial you will learn how to configure trunk in switches.

forward collision warning not working nissan

.

1Q and assign VLAN 10 to the subinterface. 4) Configure your L2 switch in VTP client mode initially to let VTP propagate the VLAN information to your switch & then hardcode it to VTP transparent. conf t. 2.